Table of Contents
Advertisement
H
, F
EADBOARD
12.1 R
T
EMOVABLE
The bed may be equipped with removable tiltable
siderails. The tilting mechanism of the siderails is used
to tilt the siderail along the bed bearing area.
Tilt the siderail as follows:
Grasp the siderail with one hand by its top
•
crossbar (1)
Lift the locking lever of the siderail (2)
•
Tilt the siderail towards the legs (3)
•
Lift the siderail by pulling it upwards and
•
it automatically locks in the maximum
position (4)
Remove the siderail as follows:
Pull both locking pins (5) toward the floor and turn (6) by
•
90° - they are locked in the unlocked state
•
Move the siderail out of the bed (7)
To place the siderail back to the bed, proceed by analogy
•
Once the siderail is placed, secure the locking pins back
•
to the locked position by turning by 90°
The bed may be equipped with a double locking mechanism to
protect the control lever of siderails against accidental activation. To
tilt the siderails, press the safety lever (9) downwards first and at
10
9
When handling the siderails, make sure that there is no foreign object between the individual bars of
siderails. It could result in damage or bodily harm!
When removing the siderails, hold them always with both hands and check their trajectory all the time.
Failure to do it could result in personal injury due to the impact by the siderail or squeezing!
Always make sure that the siderail is properly secured against spontaneous removal before any further
use. Otherwise, the siderail would not comply with restrictive measures against the patient falling out of
the bed. It could result in serious injury and bodily harm!
After pulling the siderail to the maximum position, always make sure that the siderail is properly secured.
Hold the siderail with hand and pull it towards the footboard of the bed. The siderails in this test must
remain in the elevated position!
Instructions for Use of VERTICO Bed
S
OOTBOARD AND
IDERAILS
S
ILTABLE
IDERAILS
the same time, pull both levers (10)
upwards. The siderail is released. Then
proceed in the same way as with the
control lever without protection.
3
2
Page 17/32
1
4
7
5
6
5
6
Advertisement
Table of Contents
