Table of Contents
Advertisement
12.5.1
STACKING RACK FOR BEDDING
The bed may be equipped with an extension rack for bedding located under the calf part of the
bearing area. To use it, follow the steps below:
Level the bed to the horizontal position (the bedding rack cannot be used in
•
combination with the Anti-Trendelenburg position)
•
Grasp the rack by its outer frame and pull it out from the bed (1)
Tilt the smaller tilting part (2)
•
Do not overload the rack! Maximum permissible load on the outer edge is 3 kg!
•
Tilt the tilting part back into the frame (2) before inserting it
•
Beware of squeezing when inserting the rack back under the bed
•
The extension rack may only be used, if it is not necessary to adjust the bearing area position. Otherwise, the
extension rack could collide with the surrounding objects or floor. It could cause serious injury to the operator,
damage to the surrounding items or the bed itself!
Beware of squeezing when inserting the rack back under the bed!
The bedding rack is only used for a short-term placement of the bedding when changing it. Maximum
permissible load on the outer edge is 3 kg. It is forbidden to sit on the rack or overload it. It could result in
irreversible damage!
12.6 A
H
CCESSORY
The bed may be provided with stainless steel accessory holders, the so-called
"Eurobars", located under the pelvic part on both sides of the bed. Each holder contains
sliding hooks determined for hanging tiny accessories and urological accessories.
Maximum load per one hook is 3 kg. The higher load shall be evenly distributed over multiple hooks. The load
on one hook must not exceed the maximum permitted load!
Instructions for Use of VERTICO Bed
"E
"
OLDERS
UROBARS
Page 20/32
2
1
Advertisement
Table of Contents
