Fisher & Paykel DE4560M Installation Instructions Manual page 2

2. Tilt the dryer backwards and 'walk' it off the base one foot at a time. Not doing so may cause damage to your
floor and dryer.
3. Remove all packaging and accessories from inside the drum and ensure you remove protective covers from
the door and console.
Location
Venting
Correct installation is very important for all dryers to ensure maximum efficiency and safety.
Never run the dryer unless the airflow system is free from obstruction.
There must be adequate ventilation to avoid the back flow of gases into the room from appliances burning fuels,
including open fires, when operating the dryer.
Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other
fuels.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Vented/DE4560M1/User_Guide_DE4560M1/03_Installation_Instructions
• The dryer must be installed in a well-ventilated,
dust-free environment.
• The dryer must not be installed on any textured
floor coverings (eg carpet, rugs).
• Do not install the dryer behind a lockable door,
sliding door, or behind a door where the hinge is
on the opposite side to that of the dryer in such
a way that the full opening of the door is
inhibited. Ensure the dryer door can always be
opened fully.
• Do not install the dryer outside, in a damp place,
where there is a risk of freezing, where it
may be rained on, in direct sunlight or close to
a source of heat.
• Do not place your dryer on top of its power
cable.
Updated: Thu, 27 Jan 2022 05:02:50 GMT
Powered by
2