Wall Mounting - Fisher & Paykel DE4560M Installation Instructions Manual

Wall Mounting

1. Determine the position of the dryer on the wall
and mark the bracket position. A minimum of
50mm is needed between the top of the dryer
and the ceiling for ease of installation. If
mounting above a washing machine,
allow sufficient room to open the lid of the
washer. Refer to 'Inverted Wall Mounting' for
lid clearances.
2. Fix the wall hanging brackets to the wall
securely, ie into the stud. If the studs are too far
apart, fit a timber slat to the studs and then
mount the brackets to the slat. If a slat is used,
install a second slat behind the spacers to
ensure the dryer is horizontal. The distance
between the centre of each bracket is 555mm
(A).
3. To install the hooks onto the dryer, remove one
screw from each side (B), reuse these
screws with two more (each side) from the kit to
fasten the hooks in place.
4. Remove plastic plugs from the back of the dryer
and screw the spacers provided in place (C).
5. With assistance, mount the dryer on the wall
brackets.
6. Fit inverted control panel over the existing
panel.
7. Adjust the display to read correctly on an
inverted panel:
◦ For DE7060M, DE6060M and DE5060M
press
and
for three seconds.
◦ For DE4560M press
and
for three seconds.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Vented/DE4560M1/User_Guide_DE4560M1/03_Installation_Instructions
Updated: Thu, 27 Jan 2022 05:02:50 GMT
Powered by
7