Base Terminal Definitions - Veesta World V-PM2000 Series User Manual

VP-2040 Enhanced IED
V-PM2000 Series, Veesta Power Measurement
Instructions & User's Manual
6.2.1

Base Terminal Definitions

No. Code
1 L/+
2 --
3 N/-
4 --
5 FG
6 --
7 (Not Exist)
8 (Not Exist)
9 I32
10 I31
11 I22
12 I21
13 I12
14 I11
15 A+
16 B-
17 Sg
18 --
19 --
20 A1
(option)
21 Ag
(option)
22 VN
23 --
24 V3
25 --
26 V2
27 --
28 V1
All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization.
In regarding the only base unit used, there are 2 rows terminal and
the terminal numbered from 1 up to 28. Please pay attention that
terminal with code (--) tagged as NC (Not Connect), so you should
leave this terminal float and disconnect to any wiring.
Table 6-1: VP-2040 Base Terminal Definitions
Definition
Positive of power supply
--
Negative of power supply
--
Earth protection Field Ground System
--
Phase C current outgoing line
Phase C current incoming line
Phase B current outgoing line
Phase B current incoming line
Phase A current outgoing line
Phase A current incoming line
Positive pole of RS485 (A)
Negative pole of RS485 (B)
Communication shielded earth of RS485
--
--
Positive pole analog output (If AO option selected)
Negative pole of Analog Output (If AO option selected)
Voltage neutral line
--
Phase C voltage
--
Phase B voltage
--
Phase A voltage
Chapter 6 - Unit Installation
Page 38 of 100