Set-Points To Alarms; Communications; Upgrade To Future Expansion - Veesta World V-PM2000 Series User Manual

VP-2040 Enhanced IED
V-PM2000 Series, Veesta Power Measurement
Instructions & User's Manual
1.2.4

Set-points to Alarms

1.2.5

Communications

1.2.6

Upgrade to future expansion

All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization.
Any of the assignable output relays may be used to trigger and alarm
for specific applications.
Table 1-1: VP-2040 Set-points condition table
Condition
Over current
Under current
Over load
Over line voltage
Under line voltage
Over phase voltage
Under phase voltage
Phase lost
Over frequency
Under frequency
Switch input
Integrate process, instrumentation and electrical requirements in a
plant automation system by connecting VP-2040 meters together to a
DCS or SCADA system. A PC running the VP-2040 can change
system set-points, monitor values, status and alarms. Continuous
monitoring minimizes process downtime by immediately identifying
potential problems due to faults or changes from growth.
 RS485 ModBus® 4,800; 9600; 19,200; 48,400 bps
 RTU SCADA system component
 Measure actual values
 Read status
 Issue control commands
 Load all set-points
 Change individual set-points
The VP-2040 has ability to expansion module during ordering. Bellow
type of expansion module can be order:
 Option A: 4 x Status inputs + 4 x Relay outputs
 Option B: 8 x Status inputs + 2 x Relay outputs
 Option E: 8 x Status inputs + 2 x pulse outputs
 Option P: PROFIBUS communication module
Chapter 1 - Introduction
Application
Motors / transformers
Pumps / compressors
Motors / transformers
Equipment protection
Motors / load transfer
Equipment protection
Motors / load transfer
Pumps / equipment
Generators
Load shedding
Process control
Page 12 of 100