Standard Features; Metering - Veesta World V-PM2000 Series User Manual

VP-2040 Enhanced IED
V-PM2000 Series, Veesta Power Measurement
Instructions & User's Manual
1.2.2

Standard features

1.2.3

Metering

All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization.
 2 controlled relay outputs
 1 analog output to a transducer function
 2 pulse outputs based on KWH, KVarH, KVAH or AH
 50 SOE Event log records
 Minimum / maximum logger
 harmonic analysis through 31rd
 Triggered memory (Fault recording)
 Demand calculation and maximum recording.
 Build-in clock
 Large high-contrast LCD screen, easy for operating and
setting with password lock
 RS485 serial port
 ModBus® RTU protocol
The VP-2040 of panel mount type with display is easy to local
interface. Standard models offer RS485 ModBus® communications
for programming and monitoring. To replace expensive additional
devices as control output, transducer output and power analysis use
with auxiliary I/O monitoring can be required to the VP-2040 option
series.
Each voltage and current is sampled 64 times per cycle for 0.2%
accuracy true RMS measured values.
 Ia, Ib, Ic, In
 Va, Vb, Vc, Vab, Vbc, Vca
 W, Var, VA, total & individual
 Hz & phase rotation sequence
 Current & Voltage Unbalance
 True PF & K factor
 WH, VarH
 Demand: A, W, Var, VA
A keyboard and light contrast LCD display module are used for field
programming, setup monitoring values and status.
Chapter 1 - Introduction
Page 11 of 100