Optional Auxiliary Monitoring; Communication Port; Alarms Trip Set-Point - Veesta World V-PM2000 Series User Manual

VP-2040 Enhanced IED
V-PM2000 Series, Veesta Power Measurement
Instructions & User's Manual
3.1.4

Optional Auxiliary Monitoring

1. Digital Input (DI)
2. Control Output (CO)
3. Analog Output (AO)
4. Pulse Output (PO)
3.1.5

Communication Port

1. Rear panel port
2. Communication Protocol :
3.1.6

Alarms trip set-point

1. Set points
All rights reserved. Passing on and copying of this document, use and communication of its contents not permitted without written authorization.
: 4 or 8 status input by option choose
Internal powered of DC 30V
Input / dry contact
: 2 or 4 Relay outputs by option choose
Dry contact form A SPST
Contact material: gold plate silver alloy
Normal operation:
- 220Vac / 30Vdc, 5A resistive
: 1 Analog output by option choose
Accuracy, 0.5% fs
Standard output: 4-20mAdc
Load resistance 400Ω
Configurable:
- Measured parameters
- Input range, uni-polar / bipolar
: 2 pulse outputs photo-isolated by option choose
Configurable:
- Parameter: WH / VarH
- Unit: ±1WH / ±1QH
Pulse width: 80 ms, 50% duty cycle
: RS-485 Network 2 wires for networking to master
Baudrate: 4800, 9600, 19200, 38400bps
ModBus RTU Protocol
Address: 1~247
: 44 set point,
Over current, under current, over voltage, under
voltage, over load, phase lost, over frequency,
under frequency, status change
Circuital set-value
Time delay
Chapter 3 - Specifications
Page 19 of 100