9.3 Input and Output Signals
9.3.1 Input and Output Signals
(1) Input signals to the printer
DATA
STB
RESET
(2) Output signals from the printer
ACK
BUSY
FAULT
SELECT
COMPULSION
PE :
(3) Power related signal
GND
Vcc
: An 8-bit parallel signal. (Positive logic)
: A strobe signal to read the 8-bit data. (Negative logic)
: A signal to reset the printer from the outside.(Negative logic)
: An 8-bit data request signal. A pulse signal output at the end of the BUSY signal.
(Negative logic)
: A signal to indicate the BUSY status of the printer. Input new data when at
"LOW". (Positive logic)
: A signal turned to "LOW" when the printer has an alarm. At this time, all the
control circuits in the printer stop. (Negative logic)
: A signal to show whether the printer is selected(on-line) or deselected.(Positive
logic)
: A signal to show the status of the drawer switch.(Positive logic)
A signal to show that the paper has run out. Normal at the "LOW" level, but turned
to the "HIGH" level when the paper has run out.
: Common ground on the circuits
: A +5V signal. Connected via a 3.3k resistor.
21
iDP3410 User's Manual
CITIZEN