Citizen pmn User Manual page 112

ESC "v"
[Function]
[Code]
[Outline]
[Caution]
Sending the printer status
<1B>H <76>H
This command sends the printer status.
This command is valid only for the serial interface. The following table lists the status
sent. In case of DTR/DSR control, only one byte will be sent after confirming that the
host is ready to receive (DSR signal has the Space status).
The status at command processing time is sent after processing the data received prior to
this command. If the printing is under way when the command is being processed,
however, the then status will be sent after completing print feed of that line. Therefore, it
may take time to send the status after receiving the command.
Bit Function
0 Paper near end
1 Undefined
2 Paper near end
3 Undefined
4 Undefined
5 Undefined
6 Undefined
Value
0
With paper
With paper
0 stationary
98
iDP3410 User's Manual
1
Near end
End
CITIZEN