Setup Interface To Dji Autopilot - UGCS SkyHub User Manual

Setup Interface to DJI Autopilot

Setup Interface to DJI Autopilot
To allow the UgCS SkyHub to connect to the DJI autopilot, one should activate and setup the
Onboard SDK for its device. The following steps are described for the DJI A3 flight controller
but may be applied to another DJI product with a minor difference.
Option 1: Using Default Credentials (Recommended)
It is recommended to use default credentials provided with the software pack:
• Login: app@djidev.com
• Password: request when ordering the kit
1. Connect the DJI flight controller to the PC, run the DJI Assistant 2, and press the Login
button.
2. Enter the credentials mentioned above and press Sign in.
Copyright © 2019—2021, SPH Engineering
Figure 12.3 — DJI Assistant 2 start window
49
UgCS SkyHub User Manual
Revision 5 • November 2021