Conductivity Meter Setup - UGCS SkyHub User Manual

Conductivity Meter Setup

See Geonics EM-61 Configuration
descriptions.
Conductivity Meter Setup
There are common conductivity meter settings in the [CONDUCTIVITY_METER] section.
Check whether minimum and maximum values correspond to your needs:
[CONDUCTIVITY_METER]
MIN_OUTPUT_VALUE_MS_M=0
MAX_OUTPUT_VALUE_MS_M=500
These values are used to bound valid conductivity values. When the conductivity is out of the
limits, the operator will be notified.
Geonics EM38-MK2 Setup
1. Set GEONICS_EM_38_MK2 item to true in [PAYLOADS] section:
[PAYLOADS]
GEONICS_EM_38_MK2=true
2. Choose the appropriate CONNECTION_TYPE in the [GEONICS_EM_38_MK2] section:
[GEONICS_EM_38_MK2]
CONNECTION_TYPE=BLUETOOTH ; connection through bluetooth
; or
CONNECTION_TYPE=RS232 ; connection through RS323
3. Choose the appropriate CHANNEL_NUMBER in the [GEONICS_EM_38_MK2] section
to display the desired value on the Conductivity Meter widget in UgCS-CPM. For
example, to display the conductivity for 1.0 m set channel to 3:
[GEONICS_EM_38_MK2]
CHANNEL_NUMBER=3
See Geonics EM38-MK2 Configuration
descriptions.
Important: to connect through RS232 should use the USB-UART adapter.
Important: should calibrate the conductivity meter before using it according to the
manufacture documentation.
Copyright © 2019—2021, SPH Engineering
to find all available settings with default values and
to find all available settings with default values and
72
UgCS SkyHub User Manual
Revision 5 • November 2021