Troubleshooting - Icom IC-R2 Instruction Manual

If your receiver seems to be malfunctioning, please check the
following points before sending it to a service center.
PROBLEM
No power comes ON. • The batteries are exhausted.
• The battery polarity is reversed.
No sound comes from the • Volume level is too low.
speaker. • Different tone is selected with tone squelch.
Frequency cannot be set. • The lock function is activated.
• Channel indication mode is selected.
No beeps sound. • Beep tones are turned OFF.
Receive audio is • The operating mode is not selected correctly.
distorted.
Desired set mode item • The desired set mode item is in expanded set
cannot be selected. mode.
• Some set mode items cannot be selected in
the broadcast band.
POSSIBLE CAUSE

TROUBLESHOOTING

SOLUTION
• Replace the batteries.
• Check the battery polarity.
• Push [VOL Y] to obtain a suitable level.
• Check the tone using tone scan.
• Push [FUNC] + [ LOCK] to cancel the function.
(MODE)
• Turn the channel indication mode OFF in set mode.
• Turn beep tones ON in set mode.
• Select a suitable operating mode in set mode.
• Turn the expanded set mode ON.
• Choose a band other than the broadcast band.
11
REF.
p. 1
p. 1
p. 10
p. 23
p. 8
p. 29
p. 26
p. 11
p. 25
p. 25
31