Accessory Attachment - Icom IC-R2 Instruction Manual

D Antenna
Insert the supplied antenna into the an-
tenna connector and screw down the an-
tenna as shown at right.
Keep the jack cover attached when jack
is not in use to avoid bad contacts from
dust and moisture.
Commercially available antennas may increase receiver per-
formance. An optional AD-92SMA
is available to connect an antenna with a BNC con-
ADAPTER
nector.
D Battery installation
q Remove the battery cover
from the receiver.
w Install 2 R6 (AA) size al-
kaline, dry cell or Ni-Cd
batteries.
• Be sure to observe the cor-
rect polarity.
• Charge Ni-Cd batteries be-
fore use. (See the separate
BC-127A/D instruction
sheet.)

ACCESSORY ATTACHMENT

ANTENNA CONNECTOR
Keep battery contacts clean. It's a good idea to clean bat-
tery terminals once a week.
D Belt clip
Conveniently attaches to
your belt.
Slide the belt clip into the
plastic loop on the back of
the receiver.
D Handstrap
Slide the handstrap through the loop
on the side of the belt clip as illus-
trated at right. Facilitates carrying.
1
1