Technical Data - Otto Bock Dino 3 User Manual

Technical data
13.2. CE Conformity
This product meets the requirements of the European Directive 93 / 42 / EEC for medical devices. This product has
been classified as a class I device according to the classification criteria outlined in Annex IX of the directive. The
declaration of conformity was therefore created by the manufacturer with sole responsibility according to Annex VII of
the directive.
13.3. Warranty
Further information on the warranty terms and conditions can be obtained from the qualified personnel that has fitted
this product or the manufacturer's service (see inside back cover for addresses).
13.4. Service Life
Expected service life: 4 years.
The design, manufacturing and requirements for the intended use of the product are based on the expected service
life. These also include the requirements for maintenance, ensuring effectiveness and the safety of the product.
Using the product beyond the specified expected service life leads to increased residual risk and should only take
place subject to the due diligence and deliberations of qualified personnel.
If the service life is reached, the user or a responsible attendant should contact the qualified personnel who fitted the
product or the manufacturer's servicing department (see inside rear cover or back page for address). Here the user
can obtain information about known risks and the current options for refurbishing the product.
13.5. Trademarks
All product names mentioned in this document are subject without restriction to the respective applicable trademark
laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of the respective
owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justify the conclusion that
the denotation in question is free of third-party rights.
14

Technical data

Dimensions of the Dino 3 (in mm)
14.1. Overall length
Max. wheelbase
Min. wheelbase
Length with
single-panel footrest
14.2. Overall height
Pushbar standard
in highest position,
back 90°
Pushbar standard
in lowest position,
back 90°
Seat tubes
with 0° seat tilt
14.3. Overall width
360
400
440
Seat tube depth (front edge of back tube to front edge of seat tube) 355 mm
32 | Ottobock
Rear wheel 12.5"
770
770
889
Rear wheel 12.5"
Hole pos. Hole pos.
lower upper
1200 1125
1040 965
485 435
Rear wheel 12.5"
540
580
620
Rear wheel 22"
930
800
1060
Rear wheel 22"
Hole pos. Hole pos.
lower upper
1127 1145
967 985
455 435
Rear wheel 22"
600
640
680
Rear wheel 24"
955
825
1085
Rear wheel 24"
Hole pos. Hole pos.
lower upper
1152 1170
992 1010
480 460
Rear wheel 24"
600
640
680
Dino 3