Table of Contents
Advertisement
WARNING!
!
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
• Disconnect the appliance from the mains
electricity supply before carrying out any work
or maintenance.
• Connection to a good earth wiring system is
essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician.
WARNING!
!
Cut Hazard
Failure to use caution could result in injury.
• Take care: some edges are sharp.
SAFETY AND WARNINGS
READ AND SAVE THIS GUIDE
General Use
Suitable only for indoor installation.
z
Do not modify this appliance
z
Read these instructions carefully before installing this product.
z
Save these instructions for the local electrical inspector's use.
z
Installation must comply with your local building and local electricity regulations.
z
This appliance is to be installed and serviced only by a Fisher & Paykel trained and
z
supported service technician or qualified person.
The manufacturer accepts no responsibility for the incorrect installation of appliances.
z
Incorrect installation may result in personal injury, damage to property and may
invalidate any warranty or liability claims.
Packing elements (eg plastic bags, polystyrene foam, staples, packing straps etc) and
z
tools should not be left around during and after installation, especially if they are within
easy reach of children, as these may cause serious injuries.
Make sure you recycle the packaging material.
z
Before disposing of any appliance, make sure that it can no longer be used and that all
z
hazardous parts are removed or made harmless, so that children playing with the old
appliance cannot harm themselves.
Only genuine replacement parts may be used for servicing the appliance. These are
z
available from your nearest Fisher & Paykel Service Centre.
These appliances are registered in: New Zealand at www.energysafety.govt.nz and
z
Australia with SAI Global at www.saiglobal.com.
Appliances are factory set for natural gas but are convertible to ULPG. If in doubt, refer
z
to the local gas network operator or gas supplier to confirm gas type at installation site.
Do not modify this appliance.
z
Do not use or store flammable materials on or near this appliance.
z
Do not spray aerosols in the vicinity of this appliance while it is in operation.
z
This cooktop must be connected to the mains power supply only by a suitably
z
qualified person.
Do not use adapters, reducers, or branching devices when connecting the cooktop to
z
the mains power supply to prevent overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that
z
its temperature will not exceed 75°C at any point.
This cooktop requires adequate supply of cool air to fully function. The base of the
z
cooktop must have direct, unrestricted ventilation to the room where the cooktop
is installed. There must be a 4mm air gap at the front of the cooktop. (See 'Venting
Clearances' page)
3
Advertisement
Table of Contents
