599266B Contents MODELS COVERED BY THIS MANUAL........................5 SERVICE ASSISTANCE..............................5 SERVICE REQUIREMENTS ..........................6 1.1 H ............................6 EALTH AND AFETY 1.2 G ............................6 ENERAL WARNING SPECIFICATIONS ...............................7 2.1 P ............................7 RODUCT OVERVIEW 2.2 M ..............................7 ODEL NUMBER 2.3 S ..............................8 ERIAL NUMBER 2.4 E ...............................8 LECTRICAL...
599266B Service requirements 1.1 Health and Safety When servicing the cooktop, health and safety issues must be considered at all times. Specific safety issues are listed below with their appropriate icon. They are illustrated in the service procedures to remind service people of the issues. Electrical safety.
599266B Specifications 2.1 Product overview Model CG913T CG913TM Supply voltage 220/240 220/240 Flame failure auto reignition Brushed stainless steel panels Iridium stainless steel panels Wok burner 14000 BTU/h 20000 BTU/h LED burner indicators, innovalves, shut off solenoid 2.2 Model number Note: A model and serial number label is located on the underside of the cooktop and on the cover of the use and care guide supplied with the product.
599266B 2.3 Serial number The serial number consists of three letters and six digits and contains the information shown in the following example: B R M 123456 Sequential serial number Manufacturing plant code FISHERPAYKUL code indicating month of manufacture CUMBERLAND code indicating year of manufacture Cumberland code Letter C Year 1...
599266B Ignition, flame sensing and auto reignition 5.1 Ignition sequence Burner knob is turned on LED turns on Takes approximately 2 seconds Ignition box does a self check Shut off solenoid is energised allowing gas to flow into the manifold and through the gas tube Takes approximately 2-3 seconds.
599266B 5.3 Auto reignition The ignition box will sense when a flame has gone out (when a burner knob is in the ON position) and try to reignite the flame. All the electrodes will spark during reignition. During reignition the ignition box allows a period of approximately five seconds for the burner to light.
599266B Servicing Procedures Refer to the Service requirements before servicing, Section 1 page 6 6.1 To remove the hob top and tray 1. Lift off the trivets and burner components. 2. Remove the knobs. 3. Remove the screws securing each burner. To prevent damaging the screw head use a No.
599266B 6.5 To remove the ignition switch loom 1. Remove the hob top and tray. 2. Lift the loom switches off the gas valves and unplug from the ignition box. 6.6 To remove the transformer 1. Remove the hob top and tray. 2.
599266B 6.8 To service a gas valve 1. Remove the hob top and tray. 2. Remove the ignition switch loom. 3. Remove the screws on the body of the gas valve. 4. Gently lift out the valve cone and clean with solvent. 5.
599266B – CG913 Gas cooktop Fault finding Sparking continuously Does the Is a burner in Check for shorted igniton switches in the burner light? use? Refer to Burner not lighting flowchart loom. Check the: Is the flame burner components are assembled correctly, are clean and dry behaving and not distorted normally***?