Table of Contents
Advertisement
1
adhesive
2
elbow* washer
3
16
Prepare the countertop for flush
installation. Use a router to cutout
the edges of the countertop to
specified depth (5mm).
Attach an adhesive tape along
the edges of the routered recess.
Fit the elbow and washer to the
floating nut. Turn the cooktop
over carefully and place onto a
protected surface.
floating nut
Gently lower the cooktop into the
cutout ensuring you have access
below the countertop to fit and
secure the brackets.
*The number of brackets varies based on your cooktop model
FLUSH INSTALLATION
4
5
6
7
Locate the side brackets* to the
appropriate slots on the cooktop
chassis. The correct slot height is
determined by the thickness of
your countertop.
Tighten all screws to secure the
cooktop to the countertop.
Ensure cooktop is level.
Mask off the area to be siliconed
ensuring both the cooktop and
countertop are protected.
Apply silicone in the gap between
countertop and cooktop.
Wipe off any excess silicone.
Advertisement
Table of Contents
