Fisher & Paykel AQUASMART WL26CW1 Service Supplement Manual page 39

(a) Follow procedures for removal of pump hood & cap (refer to Section 17.11).
(b) Spin the impeller by hand (it should be free to turn in both directions).
resistance, try and locate the object. If the object can be located, remove and recheck for free
movement of the impeller. Also ensure that the ports, flapper, chamber and SLR feature (refer
to Section 8.3) are clean and free of lint or other obstructions.
Note: If there appears to be a foreign object trapped under the impeller and it cannot be
freed by using the above procedure, it may be possible to clean out under the impeller area
by holding it under running water while spinning the impeller. To do this the pump housing
must be removed from the machine. If this fails to clear the obstruction, then the pump will
have to be replaced. To remove the pump housing, refer to Section 17.13.
(c) Refit the pump hood and cap ensuring the correct orientation.
(d) If water is in the machine, enter diagnostic mode and run the pump (refer to Section 14) to
drain the remaining water from the machine.
(e) After the water has drained, check for any other objects in the bowl.
On completion of service we recommend carrying out the SmartPump™ test routine (refer to
Section 8.5).
39
517794B
If there is any