Data Download; Showroom Mode; Fault Codes - Fisher & Paykel AQUASMART WL26CW1 Service Supplement Manual

14.3

Data Download

To activate the data download, enter the diagnostic mode (refer to Section 14), then press the
START/PAUSE button. The LED above the High Efficiency button will be on and flickering.
Place the download pen over this LED and follow the instructions supplied with the data download
program.
14.4

Showroom Mode

Showroom mode will play the introduction and repeat it continuously, until the power supply has
been isolated from the power supply.
To access the showroom mode follow the steps below.
(a) Turn the power supply to the washing machine on.
(b) During the introduction sequence on the LCD display (which lasts for approx. 1 minute) press
and hold the Start/Pause button and the Select button, and hold these buttons for at least two
seconds.
To exit, turn off the power supply to the washing machine at the wall.
15

FAULT CODES

The fault codes and their detailed descriptions for the AquaSmart™ washing machine have been
added to the master service manual, part number 517790D.
The new fault codes for AquaSmart™ are:
26. (00011010) Detergent Valve Fault
27. (00011011) Fabric Softener Valve Fault
49. (00110001) Cold Valve or Cold Valve & Hot Valve Faulty
220. (11011100) EEPROM Model Map Not Programmed
245. (11110101) SmartPump™ Stall
247. (11110111) SmartPump™ Flapper Fault
248. (11111000) SmartPump™ Top Up Fault
249. (11111001) SmartPump™ Timeout Fault (No change in the water level)
250. (11111010) SmartPump™ Loss Of Sync
LED for data download
Press and Hold Start/Pause, the press the Select button
29
517794B