Table of Contents
Advertisement
Enabling control panel menus
1
Turn the printer off.
2
Press and hold
3
Release both buttons when Performing Self Test appears on the display.
The printer performs its power-on sequence, and then Config Menu appears on the first line of the display.
4
Press
until
5
Press
until
The following messages appear briefly in succession: Submitting Selection and Enabling Menus.
The control panel returns to Panel Menus.
6
Press
until
Activating Menu Changes appears. The menus are enabled.
Resetting the Printer appears briefly followed by a clock. The control panel then returns to Ready.
Restoring factory default settings
When you first enter the printer menus from the control panel, you may notice an asterisk (*) to the left of a value in the
menus. This asterisk indicates the factory default setting. These settings are the original printer settings. (Factory defaults
may vary for different regions.)
When you select a new setting from the control panel, Submitting Selection appears. When the Submitting Selection
message disappears, an asterisk appears next to the setting to identify it as the current user default setting. These settings
are active until new ones are stored or the factory defaults are restored.
To restore the original printer factory default settings:
Warning:
All downloaded resources (fonts, macros, and symbol sets) in printer memory (RAM) will be deleted.
(Resources residing in flash memory or on the optional hard disk remain unaffected.)
1
Make sure the printer is on and Ready appears on the display.
2
Press
on the control panel.
3
Press
until
4
Press
until
5
Press
until
6
Press
until
7
The message Restoring Factory Defaults appears, followed by the Ready message.
When you select Restore:
•
No other button actions are available on the control panel while Restoring Factory Defaults appears.
•
All menu settings return to the factory default values, except:
–
The control panel Display Language setting in the Setup menu.
–
All settings in the Parallel menu, Network menu, and USB menu.
Administrative support
and
while turning the printer on.
Panel Menus appears, and then press
Enable appears, and then press
Exit Config Menus appears, and then press
Settings appears, and then press
Setup Menu appears, and then press
Factory Defaults appears, and then press
Restore Now appears, and then press
Enabling control panel menus
.
.
.
.
.
.
.
61
Advertisement
Table of Contents
