Configuration Using The Control Panel - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Configuration Using The Control Panel

SMART
You can set Ethernet Interface settings from the printer control
panel.
CAUTION
When the printer is first powered on, the message "E-NET
INIT" displays on the control panel. This process takes about
two minutes. To prevent a loss of Ethernet Interface
configuration information, do not change the Ethernet
Interface settings while this message is displayed. When the
initialization is complete, the message "E-NET READY"
displays, and you can safely change the Ethernet Interface
settings from the control panel.
1. You can set any of three listed parameters from the printer
control panel. These parameters are located in the Arrange to
have an IBM service technician install the Ethernet Interface
card if it is not already installed; this is not a customer
installable feature.
2. Power on the printer. The message "E-NET INIT" appears
when the printer is powered on. Configuration can be done
after the "E-NET READY" message appears (about 1 to 2
minutes after the "E-NET INIT" message displays).
3. Disable the Power Saver mode before starting this procedure,
see the 4400 Setup Guide for instructions.
4. Always print an E-NET test page before performing any
updates or network configuration using the following steps:
For 4400 printers:
a. Take the printer offline. When the printer LCD reads,
"OFFLINE," press the
unlock the control panel.
b. Press the + key until "PRINTER TESTS" appears. Continue
pressing the + key until "PRINTER TESTS/E-NET TEST
PAGE" appears. Press .
Configuration Using The Control Panel
and keys simultaneously to
35