6.5 Door catch and strike
This is a mechanical type strike and catch, when the door is pushed closed the strike is locked into the
catch and holds the door shut.
6.6 Door micro switch
The door switch is connected to the electronic controller ensuring that when the door is open, voltage to
the motor and elements are cut.
6.7 Main motor (two different types)
Make
Type
Power (max)
Voltage/ Frequency
Run capacitor
Make
Type
Power (max)
Voltage/ Frequency
Run capacitor
6.8 Mechanical parts (Dynamic system)
The main motor is held within a cradle mounted to the base of the dryer. In order to drive the drum,
a poly-v belt is used between the motor pulley and drum. The belt is tensioned via an idler pulley and
tensioner spring attached directly to the motor.
The stainless steel drum is mounted onto the front bearing housing. The rear bearing is fixed to the inside
of the drum by 4 screws and mounted to the heater plate.
The heater is mounted to the element carrier and bolted on to the drum through the rear bearing which
is attached to the cabinet.
17
Sanjang
Split phase reversing
150W
220-240v 50 Hz
6uF
Broad Ocean
Split phase reversing
150W
220-240v 50 Hz
6uF
Red - Orange
116Ω +/- 10%
Red - Blue
58Ω +/- 10%
Orange - Blue
58Ω +/- 10%
Red - Orange
96Ω +/- 10%
Red - Blue
48Ω +/- 10%
Orange - Blue
48Ω +/- 10%