Table of Contents
Advertisement
Installation – Door-vented auto-timer dryer
8
Dryer position
The Door-vented auto-timer dryer is front
venting, whereby the air is taken in through
the grill at the rear of the dryer and vented
out through the grill in the door at the front.
The dryer should be positioned so that the air
intake at the rear is unrestricted. The minimum
clearance needed from the wall is 50 mm.
Included with this dryer are two plastic spacers.
Fitting these on the rear of the dryer will ensure
the dryer is correctly positioned away from the wall.
Use screws provided to fit the spacers (as shown in
■ ■
the diagram).
Directional outlet grill
The outlet grill can be rotated to direct the exhaust
air. It should be adjusted so that it points towards an
external window or door.
Specifications
Dimensions
Width
Depth
Height
Electrical
Volts
Hz
Amps
Note: if the electrical supply cord is damaged it must be replaced by the manufacturer or a
Fisher & Paykel Authorised Repairer in order to avoid a hazard.
Electronic auto-sense and
Rear-vented auto-timer dryers
565 mm
560 mm
810 mm
NZ/AU/SG
230/240
50
8.0
Fig. 10 Spacers
Fig. 11 Directional outlet grill
Door-vented auto-timer dryer
565 mm
440 mm
810 mm
NZ/AU
230/240
50
8.0
Advertisement
Table of Contents
