Table of Contents
Advertisement
Reversing the door
Tools required:
Standard #2 Phillips screwdriver.
■ ■
Tape-tipped putty knife.
■ ■
Needle-nosed pliers.
■ ■
Remove the plug from the power outlet.
1
Open the door and remove the blanking plugs opposite the hinges. Retain the blanking plugs
2
for Step 4.
With the door completely open, remove the bottom screw from each hinge on the dryer face.
3
Insert these screws about half way into the top holes, for each hinge, on the opposite side
(where you removed the plastic plugs). Apply firm pressure to get the screw started in untapped
holes.
Loosen the top screw from each hinge on the dryer face to half way. With one hand holding
4
the top of the door and the other hand holding the bottom, remove the door from the dryer by
lifting it up and out. Remove the two remaining screws and retain for later use. Fit the blanking
plugs removed in Step 2.
Installation instructions
Fig.34 Removing the door
41
Advertisement
Table of Contents
