Cleaning; Cleaning And Inspection After Each Use - ALDI FERREX GLM44A User Manual

Cleaning

Cleaning
WARNING!
Risk of electric shock!
Moisture in the device may cause a short circuit or electric shock.
- Before cleaning, disconnect the power cable from the socket.
- Make sure that no water or other liquid gets inside the
housing.
- Never clean the device with running water (e.g. a garden
hose).
NOTE!
Improper cleaning can damage the device.
- Do not use any harsh cleaning products, brushes with metal
or nylon bristles, or sharp or metallic cleaning materials such
as knives, hard scrapers or similar. They may damage the
surfaces.
- Remove wet cuttings immediately. Residues of wet cuttings
on and in the device may harden and cause mould.

Cleaning and inspection after each use

Regular cleaning and inspection is necessary to keep the device in
perfect state.
1. Stop the motor and wait until the blade stands still.
2. Disconnect the device by unplugging the power cable and remove the power
cable from the pull relief
3. Thoroughly empty the collecting bag
without reattaching it to the device.
4. Remove cuttings from the device and the collecting bag
5. Tip the device on its side and remove cuttings from the discharge chute and
blade compartment with a hand brush or a brush.
6. Check the blade for damaged spots and wear.
16
2 .
5 (see "Emptying the collecting bag")
5 with a hand brush.