Fisher & Paykel DISHDRAWER DD60DTX6I1 User Manual page 41

Hide thumbs Also See for DISHDRAWER DD60DTX6I1:
Table of Contents

Advertisement

'A' fault codes
Follow the steps below to try and fix the issue.
DISPLAY
+ all modifiers
RINSE
,
+ all modifiers
ECO
RINSE
,
+ all
GLASSWARE
ECO
modifiers
,
+
GLASSWARE
ECO
+ all modifiers
Current wash program +
SANITIZE
FAULT CODES
POSSIBLE CAUSE
Water
A1:
Supply fault.
Drawer
A3:
cannot drain. The
drainage hose
may be blocked
or kinked, or the
connection to
drainage pipe may
be blocked.
The spray
A6:
arm has loosened
or come off its
mounting, or
water pressure
is too low, or a
combination of
low water pressure
and excessive
foaming.
Auto recovery
A7:
program –
DishDrawer™
Dishwasher
RINSE
has detected
excess foam in
the drawer.
Sanitize
A09:
cycle hasn't met
the temperature
needed to
sanitize dishes.
WHAT TO DO
1 Ensure the water supply is turned on.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Press
to resume the wash program.
1 Ensure the drainage hose and
connection to pipes are not blocked.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Press
to resume the wash program.
1 Ensure the filter is installed correctly.
Refer to 'Replacing the filter'.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Press
to resume the wash program.
1 Open the drawer and check the
spray arm.
2 If the spray arm has loosened or
come off its mounting, re-fit it. Check
that it is firmly seated and turns
freely. Refer to 'Maintenance'.
3 Press
once to stop the beeping,
then again to clear the fault.
4 Press
to resume the wash program.
1 Let the auto recovery program
run until it is complete. The wash
program will resume when the auto
recovery program has completed.
2 Check that you are using the right
detergent before running another
wash program.
3 If the drawer is still filled with foam at
the end of the wash program, contact
Customer Care.
1 Check if the water supply has
been turned off or the wash
program interrupted.
2 Press
once to stop the beeping,
then again to clear the fault.
3 Run the sanitize cycle again.
41

Advertisement

Table of Contents
loading

Table of Contents