Fisher & Paykel DISHDRAWER DD60DTX6I1 User Manual page 39

Hide thumbs Also See for DISHDRAWER DD60DTX6I1:
Table of Contents

Advertisement

PROBLEM
Fan noise after
a wash program
has finished
Fan noise starts
when I close the
drawer, even
though I didn't
start a new wash
No powdered
detergent
dispensed
The wash seems
to have finished,
but the drawer
will not open
Water pooling
on inner rim of
drawer after
a wash
Water under
the filter
Excess water in
the drawer
Water marks on
the dishes
Dents or
marks on the
drawer interior
Drawer interior
is stained
TROUBLESHOOTING
POSSIBLE CAUSES
This is normal. The fan
continues to run to assist
with drying.
This is normal. In some
cases, the fan will run
when the drawer is closed
for a set time after a
program has finished.
Detergent dispenser was
wet when loaded.
The wash is still in
progress. It is in a quiet
phase that is needed for
optimal performance.
This is normal
condensation.
This is normal.
Drain hose(s) bent.
Blocked filters.
Rinse aid depleted.
Rinse aid setting too low.
DishDrawer™ Dishwasher
overloaded/incorrectly
loaded.
This is normal. Daily
use may cause minor
cosmetic dents.
Some foods may stain the
inside of the drawer.
WHAT TO DO
The fan will automatically stop after a set
time, or when the drawer is opened. the fan
may resume when drawer is closed again.
The fan will automatically stop after the set
time is over.
Clean the dispenser and ensure it is
dry before adding detergent. Refer to
'Detergent' for more information.
No action required. The program will
transition into a more audible phase after
the quiet phase is over.
Wipe dry.
No action required.
Straighten the drain hose(s).
Refer to 'Maintenance'.
Refill the rinse aid dispenser.
Increase/turn on the rinse aid setting.
Refer to 'Loading suggestions'.
Take care when loading the
DishDrawer™ Dishwasher.
Pre-rinse dishes before placing in the
drawer. Alternatively, use
adding the dishes may minimise staining.
after
RINSE
39

Advertisement

Table of Contents
loading

Table of Contents