Fisher & Paykel DISHDRAWER DD60DTX6I1 User Manual page 38

PROBLEM
Water leaking
Knocking on the
door doesn't
pause the
wash cycle
DishDrawer™
Dishwasher
is pausing
inadvertently
Drawer will
not open
(no tones or wash
in progress)
Power failure
during wash
program
Flashing
wash modifier
indicators
Intermittent
beeping
DishDrawer™
Dishwasher will
not start
38
TROUBLESHOOTING
POSSIBLE CAUSES
Drain hose disconnected
from waste pipe.
Water inlet hose not
connected correctly.
Other leaks.
Knock to Pause sensor
is incorrectly installed
or calibrated.
Knock to Pause sensor
is recognising taps and
bumps as knocks.
is on.
KEYLOCK
Closed drawer auto lock
is on.
Power outage in your
home or area.
A fault has occurred.
DishDrawer™ Dishwasher
is paused.
Power supply is
not connected.
The drawer is not
closed correctly.
is on.
KEYLOCK
Cycle not started
Too much time passed
between pressing
closing the drawer.
DishDrawer™ Dishwasher
is in Demo mode.
WHAT TO DO
Reconnect the drain hose to the
waste pipe.
Ensure the inlet hose is connected securely.
Turn water and power supplies to the
DishDrawer™ Dishwasher off. Call Customer
Care or your Authorised Service Centre.
Contact Customer Care.
Knock to Pause sensor is incorrectly
installed or calibrated. Contact
Customer Care.
Turn
KEYLOCK
Knock once on the door and open drawer
within 30 seconds.
Wait until power resumes, program will
restart in same part of wash program.
Refer to 'Fault codes'.
Open the drawer and press
Connect the power supply.
Ensure the drawer is firmly closed.
Turn
KEYLOCK
Refer to 'Wash programs'.
Open the drawer and press
and
drawer within 7 seconds.
Contact Customer Care.
off. Refer to 'Keylock'.
off. Refer to 'Keylock'.
, close the