Fisher & Paykel DISHDRAWER DD60DTX6I1 User Manual page 34

Removing and cleaning the spray arm
spray arm
impeller
Refitting the spray arm
Removing and cleaning the filter plate
Locking nut
filter plate
Refitting the filter plate
O-ring
34
MAINTENANCE
With racking removed, lift the spray arm off the
impeller, pulling up from the centre. Shake to
dislodge any loose particles, rinse under running
water and wipe with a damp cloth. Ensure the
magnet is clean and clear and that water can flow
through all holes.
Place the spray arm onto the impeller. Ensure
that the arm rotates freely when refitted.
With the racking, drain filter and spray arm
removed, twist the locking nut anti-clockwise and
lift out. Carefully lift the filter plate out and clean
under hot soapy water before rinsing thoroughly.
Ensure the O-ring is still in place as illustrated below.
Before refitting the filter plate, ensure the O-ring is
correctly positioned within the tub as shown. If the
O-ring is incorrectly fitted before running a cycle,
product damage may occur.
Push the filter plate back into the tub ensuring there
are no particles in the recess. Secure in place by
lowering the locking nut into position, pushing down
and rotating clockwise until the arrows align.