PROBLEM
Unclean dishes
Hard water
Foaming
is flashing on
the display
is flashing on
the display
TROUBLESHOOTING
POSSIBLE CAUSES
Unsuitable wash program
for load selected.
Drawer incorrectly loaded.
Filter plate or filter
incorrectly installed.
Incorrect detergent use.
Excess food on dishware.
Spray arm holes blocked.
Spray arm rotation
blocked.
Hard water.
Incorrect detergent use.
Egg left on plates.
Rinse aid setting too high.
The spray arm rotation is
obstructed.
Routine cleaning of the
filter is due.
WHAT TO DO
Select the appropriate wash program for
the load. Refer to 'Wash programs'.
Refer to 'Loading suggestions'.
Refer to 'Removing and cleaning
the filter'.
Refer to 'Detergent' and follow the
detergent manufacturer's instructions.
Remove all food scraps prior to loading.
Clean the spray arm.
Remove any protrusions below the rack
and ensure the spray arm can rotate freely.
Increase the rinse aid setting and the
amount of detergent used. Refer to
'Water hardness'.
Increase the rinse aid setting and the
amount of detergent. Refer to
'Water hardness'.
Water softener models: Increase the water
softener setting. Refer to 'Water softener'.
Non-water softener models: If living in
an area with very hard water, consult
a plumber on installing a household
water softener.
Refer to 'Detergent'.
Rinse excess egg prior to loading.
Decrease the rinse aid setting.
Refer to 'Maintenance alerts'.
Refer to 'Maintenance alerts'.
37