Fault Pop-up
Water Level
Sensor
Disconnected
*Any of the system faults in the above table will result in the display of a fault code on the display and the
water valves turning off
The water pump will not start unless the control system detects a water level in the tank greater
than 0%.
The ability for self-diagnosis is not comprehensive, so some failures may require proper troubleshooting
practices, such as "divide and conquer", "ruling out", and "elimination".
Zamboni FastICE
®
Operating Manual
DK - 11000
Operating Manual
Cause
The system detects that the water
level sensor is disconnected. The
decision period for this is 2 seconds,
and is shorter than other decision
periods to avoid potential damage to
the water pump.
Remedy
Page 39 of 44