System Fault: Water Flow And Pressure Out Of Range: Low - Zamboni FastICE DK - 11000 Operating Manual

• Incorrect flow coefficient entered within the hidden setting screen (disregard this if the value has not
been changed from its factory setting)
• Worn hydraulic motor that drives the water pump
• Worn hydraulic pump section that supplies hydraulic oil to the hydraulic manifold
The default setting for this is 8 L/min (2 GPM) below the target flow value for at least 10
seconds. For reference, the flow rate for the Upper spray boom for a traveling speed of 8 km/hr
(5 MPH) is 41 L/min (10.5 GPM), and the flow rate for the Lower spray boom is 14 L/min (3.8
GPM) .

System Fault: Water Flow and Pressure Out of Range: Low!

This pop-up will display when there is a problem with output flow and pressure from the pump being
lower than expected by an amount that exceeds both deviation settings related to water flow and
pressure.
Problems may include:
• Clogged water filter
• An issue with the flow sensor
• Plugged water supply line between the water pump and the water flow meter
• Leaking hose connection between the pump and flow meter
• Insufficient pump speed and maximum command signal is being sent to hydraulic valve but water flow
is too low
Zamboni FastICE ® Operating Manual
DK - 11000
Operating Manual
Page 25 of 44