Table of Contents
Advertisement
Operating Manual
The "blast" function provides the opportunity for the operator to "blast" (apply water at the maximum
application rate) water where needed. It is a momentary function that is activated when the switch is
depressed, and can be activated for up to 10 seconds, after which time it will turn off and reset.
The FastICE display will provide for operator monitoring of the operational parameters, including ground
speed, water flow, water usage, water spray pressure and water temperature. It will record operational
data for later download (for record keeping or analysis) and provide troubleshooting diagnostic
information. The display has four operational display screens: Dashboard, Summary, Set-up, and
Diagnostic screens.
Navigation through the screens will be by button pushes of the Function key. An additional hidden
screen(s) may be accessed only from the Set-up screen (by pressing the Function key for (5) seconds and
releasing) and will be used for advanced technical set-up purposes.
The encoder knob of the display will be used to enter/adjust screen based operational settings. The
encoder knob will also provide alternate control of the Spray DEC-INC setting in conjunction with the Spray
switch in Switch bank 2 (only when the display is on the Dashboard screen). Either the knob or switch may
be used to make the adjustment based on the operator's preference.
DISPLAY CONTROLS
Zamboni FastICE
®
Operating Manual
DK - 11000
Page 11 of 44
Advertisement
Table of Contents
