Setting Up The Verity Scan - Hart InterCivic Verity Scan Polling Place Field Manual

setting up the Verity Scan

1. Assemble the ballot box, if this has not been done already (see page 6).
2. Place the Verity Scan on the ballot box, aligning
footpads with the indentations. The handle on
the Verity Scan must face the front of the ballot
box.

3. Reach inside the ballot box and pull the cord
down and away from you to lock the lid and the
Verity Scan in place.
4. Close and lock the front ballot box door.
5. Remove power brick and power cord from the voting equipment
5. Follow local procedures to remove the tamper seal
manuals and supplies bag.
from the Verity Scan handle, if applicable. Unlock
the case (if locked). Open the case and remove the
power brick and power cord from the storage
compartment. Close the compartment and case.



9