Setting Up The Verity Touch Writer - Hart InterCivic Verity Scan Polling Place Field Manual

setting up the Verity Touch Writer

1. Set the Verity Touch Writer on top of the booth,
aligning footpads with the indentations (the handle
on the front of the Touch Writer should face the same
direction as the handle on the booth).
2. Stand at the front of the
booth. Reach under the front
of the booth top and push
the latch away from you to
secure the Touch Writer to
the booth.

3. Follow local procedures to remove the tamper seal from
Log the yellow beaded seal number on your
the Touch Writer handle, if applicable. Unlock the case (if
Security Log - PM.
locked). Open the case and remove the power brick and
power cord from the storage compartment. Close the
Remove power brick and power cord from the
compartment and case.
voting equipment manuals and supplies bag.
4. Plug the power cord into the power brick, and then plug the power brick
into the back of the Verity Touch Writer (flat side up).
IMPORTANT: Do not plug the power cord into the wall yet.



31