Table of Contents
Advertisement
setting up Touch Writer
34
12.
Press the red button on the back of the Verity
Press the switch on the front of ballot printer, located
Touch Writer to power it on.
on the bottom right side, to power on the printer.
During the power on process, a Power-On Self Test
•
report will print on Touch Writer's built-in report
printer. This report will indicate any hardware or
connection issues; if any issues are noted, check
connections and power off the printer and the
Touch Writer. Power the printer on first before
powering on the Touch Writer.
13.
(if applicable) If your jurisdiction uses the
AutoBallot barcode reader: Wait until the
Verity Touch Writer finishes powering up
and displays the Print Zero Report screen,
and then connect the AutoBallot barcode
reader to the USB connection located on the
vDrive compartment above the report
printer.
Advertisement
Table of Contents
Troubleshooting
