Table of Contents
Advertisement
9.4 Changing the bristle disk
The purpose of the bristle disk is to direct the eyelets in the storage container
into the sorting baffle.
The plastic bristles become worn after a long period of time meaning that the
abovementioned task cannot be carried out properly.
This results in an increasing number of faults during the eyelet feed process
meaning the bristle disk needs to be replaced.
Hang OM
Carefully pull off the storage container [6] and catch the eyelets in the pre-
prepared container.
Remove the bristle disk [2/9.4.1] (as described in chapter 9.4
the bristle disk
) and the remaining eyelets also from the feed channel.
"
Separate out all of the defective eyelets.
Reattach the bristle disk.
Check the function of the bristle disk (the bristles must be long enough to
prevent the eyelets from slipping through the housing of the storage
container).
Perform all of the tasks described in the chapter
for operation
.
"
Switch the toggle switch [7/6.2.1] to "ON" and test the eye punch.
Automatic eyeletting machine 102-50
Repairs
Replacing
"
Operation - Preparation
"
33
Advertisement
Table of Contents
