Table of Contents
Advertisement
Image 9.2.3 Dismantling the lower punch
Removing the upper
punch
Installing the upper punch
30
Remove the screw [8/9.2.4] and swivel the wiper spring
[3/9.2.4] to the side.
Remove the screw [6/9.2.4] on the lower punch.
Press the lower punch through the opening [3/9.2.2] and out of the locating
borehole using a screwdriver.
Reassemble the lower punch by carrying out the steps in reverse order.
*
Perform all the tasks listed above.
Push the feed channel [1 / 7.3.1] to the side and unscrew the upper punch
[2] using the 12mm open-end spanner.
Remove the catch pin [3] from the cylinder [1].
Only ever replace the entire tool set and only ever use genuine Hang spare
parts.
Screw in the new upper punch together with the catch pin into the cylinder
by hand.
Screw the upper punch tight using the 12mm open-end spanner.
Automatic eyeletting machine 102-50
Repairs
Hang OM
Advertisement
Table of Contents
