Clutch Lever - Yamaha XSR900 2019 Owner's Manual

UBAEE0E0.book Page 14 Tuesday, December 10, 2019 2:42 PM
Instrument and control functions
See page 4-17 for an explanation
of the traction control system and
the TCS settings.
Stop/Run/Start switch " /
To crank the engine with the starter,
set this switch to " ", and then push
4
the switch down towards " ". See
page 6-1 for starting instructions prior
to starting the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
EAU54212
/ "
tery may discharge.
Drive mode switch "MODE"
WARNING
Do not change the drive mode while
the vehicle is moving.
With the throttle grip closed, press this
switch to change the drive mode (page
4-12) in the following order:
EAU12735
A → B → STD → A
" posi-
TIP
The current drive mode is shown
in the drive mode display (page
4-8).
The current drive mode is saved
when the vehicle is turned off.
4-14
ECA10062

Clutch lever

1
EAU73321
EWA18440
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
4-27.)
EAU12822