Operation And Important Riding Points; Starting The Engine - Yamaha XSR900 2019 Owner's Manual

UBAEE0E0.book Page 1 Tuesday, December 10, 2019 2:42 PM

Operation and important riding points

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
6
EAU15952
TIP
This model is equipped with:
a lean angle sensor. This sensor
stops the engine in case of a vehi-
EWA10272
cle turnover. If this happens, the
engine trouble warning light will
come on, but this is not a malfunc-
tion. Turn the vehicle power off
and then back on again to cancel
the warning light. Failing to do so
will prevent the engine from start-
ing even though the engine will
crank when pushing the start
switch.
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
6-1
EAUM3632

Starting the engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 4-27 for more informa-
tion.
1. Turn the key to "ON" and make
sure that the start/engine stop
switch is set to " ".
The following warning lights and
indicator light should come on for
a few seconds, then go off.
Oil level warning light
Coolant temperature warning
light
Engine trouble warning light
Immobilizer system indicator
light
NOTICE
If the above warning lights or indica-
tor light do not come on initially
when the key is turned to "ON", or if
EAU73430
ECA17671