Optional anti-condensate heater controller for reach-in glass doors (10 pages)
Summary of Contents for Hussmann IMPACT LW
Page 1
® PARTS LIST Item No. Quantity LWGH NOTE: Be sure merchandisers have been leveled according to the installation instructions. Carefully unpack and inspect the Wide Island Joint Kit, making sure there is no breakage or damage. Be sure factory installed align- ment pins are in place.
Page 2
B. Lift out Internal Panel. C. Remove Front Shelf Support. Center Flue Upright Foam Tape Gasket 2 in. X 3 Rows Here 3 Rows Here Hussmann Corporation • Bridgeton, MO 63044-2483 (Printed in U.S.A.) ® Donut Gasket X 18...
Page 3
Detail A Detail B Detail A GLASS 1,2,3 = STEPS IN SEQUENCE OF INSTALLATION Figure 2. Installing Joining Bolts and Connecting Cases Hussmann Corporation • Bridgeton, MO 63044-2483 (Printed in U.S.A.) Alignment Pin Location Detail B Detail A CASE 1...
Page 4
Install the Glass Post End Cover — 9, using Screws — 13. NOTE: Refer to the Installation Instruction to install the splashguard brackets. Hussmann Corporation • Bridgeton, MO 63044-2483 (Printed in U.S.A.) Glass Post Joint Extrusion Glass Glass Gasket Top View Figure 3.
Page 5
Center Trims Detail B Figure 5. Installing Trims SOLID Side Trims Detail C Hussmann Corporation • Bridgeton, MO 63044-2483 (Printed in U.S.A.) P/N 398653D Begin installing the follow- ing Trims by centering them over the case joints. Fasten Nosing Side Joint Trims —...