Installation; Nsf Certification; Location; Shipping Damage - Hussmann IMPACT LW Installation And Operation Manual

P/N 0395730F

NSF CERTIFICATION

These merchandisers are manufactured to meet
ANSI / National Sanitation Foundation (NSF
Standard #7 requirements. Proper installation is
required to maintain certification. Near the serial
plate, each case carries a label identifying the
type of application for which the case was certi-
fied.
ANSI/NSF-7 Type I – Display Refrigerator / Freezer
Intended for 75°F / 55%RH Ambient Application
ANSI/NSF-7 Type II – Display Refrigerator / Freezer
Intended for 80°F / 55%RH Ambient Application
ANSI/NSF-7 – Display Refrigerator
Intended for Bulk Produce

LOCATION

These merchandisers are designed for displaying
products in air conditioned stores where tempera-
ture is maintained at or below the ANSI/NSF-7
specified level and relative humidity is maintained
at or below 55%.
Placing refrigerated merchandisers in direct sun-
light, near hot tables or near other heat sources
could impair their efficiency.
Like other merchandisers, these are sensitive to
air disturbances. Air currents passing around mer-
chandisers will seriously impair their operation.
Do NOT allow air conditioning, electric fans,
open doors or windows, etc. to create air currents
around the merchandisers.
To prevent sweating on the exterior surfaces,
there must be a minimum clearance of 4 in.
(102 mm) between merchandisers, other fixtures
and store walls.
Product should always be maintained at proper
temperature. This means that from the time the
product is received, through storage, preparation
and display, the temperature of the product must
be controlled to maximize the life of the product.
HUSSMANN CORPORATION, BRIDGETON, MO 63044-2483 U.S.A.

INSTALLATION

Exercise caution at all times when moving
®
)
merchandisers with up-tilt riders.
They are top heavy and should NEVER be
Wide Island Fronts
B
E SURE TO POSITION WIDE ISLAND MERCHANDISER
FRONTS PROPERLY
merchandiser is readily identified by the location
of the serial plate (see leveling drawing.) Since
all electrical and refrigeration connections will be
made at the front side, the fronts will need to be
positioned according to the store plan layout.

SHIPPING DAMAGE

All equipment should be thoroughly examined
for shipping damage before and during unload-
ing.
This equipment has been carefully inspected at
our factory. Any claim for loss or damage must be
made to the carrier. The carrier will provide any
necessary inspection reports and/or claim forms.
Apparent Loss Or Damage
If there is an obvious loss or damage, it must be
noted on the freight bill or express receipt and
signed by the carrier's agent; otherwise, carrier
may refuse claim.
Concealed Loss Or Damage
When loss or damage is not apparent until after
equipment is uncrated, retain all packing materials
and submit a written request to the carrier for
inspection, within 15 days.
Do not walk or put heavy objects
WARNING
!
left in the vertical position.
. The front of a wide island
CAUTION
!
on merchandiser.
Low Temperature
1-1