Replacing Main Anti-Sweat (Honeycomb Divider) Heater; Replacing Optional Handrail Anti-Sweat Heater - Hussmann Impact F6 Installation And Operation Manual

6-8 SERVICE
REPLACING MAIN ANTI-SWEAT
(HONEYCOMB DIVIDER) HEATER
The main divider anti-sweat heater is located in
front of the rear case honeycomb.
To replace the heater:
1. Turn off power.
2. Remove screws.
3. Remove divider.
4. Unplug the anti-sweat heater lead.
5. Remove the foil barrier tape from the back of
the divider and remove the heater.
6. Install new heater, being sure to thoroughly
clean the back surface of the divider and to
install new foil barrier tape.
7. Plug in heater and reinstall divider.
P/N 0416183C
Screws
8. Turn power on.
9. Verify heater is working properly.
REPLACING OPTIONAL HANDRAIL ANTI-
SWEAT HEATER
The optional handrail anti-sweat heater is located
in front of the case under the handrail.
To replace the heater:
1. Turn off power.
2. Remove screws holding stainless steel hand
rail and turn rail to expose heater.
Stainless Steel
Top Rail
Four Screws per
4 ft. (1219 mm)
Adhesive
Foil