Joining Instructions; Offsetting Bumpers And Top Rails - Hussmann Impact F6 Installation And Operation Manual

Notes:
•B
EGIN LINEUP LEVELING FROM THE HIGHEST
POINT OF THE STORE FLOOR
•If shimming two corners, check to see if a shim
is needed in the center of the merchandiser. If a
gap exists between the support rail of the
merchandiser and the floor, a shim should be
placed in the center.

JOINING INSTRUCTIONS

Sectional construction means that two or
more merchandisers may be joined in line yielding
one long continuous display requiring only one
pair of ends. To join like fixtures, a joint kit is
required. To join unlike fixtures, or fixtures of
different temperature applications, an insulated
partition kit is required. Joint and partition kits are
shipped separately; instructions are included with
each kit.
A
LL JOINTS MUST BE AIR
FORMATION OF ICE OR CONDENSATION
Refer to separate Joint Instruction shipped
with case.
OFFSETTING BUMPERS AND TOP RAIL
Offsetting the bumpers and top rails helps to
disguise the joint locations, giving the lineup a
smoother look.
1. Locate short starter bumpers and top rail. They
are shipped with the left-end kit.
2. Remove factory installed top rails and bumpers
from cases as follows:
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
.
-
TIGHT TO PREVENT
.
.
a To remove top rails, push rail toward the
back of the case with one hand while lift-
ing the top edge off the light channel with
the other hand. See following drawing.
Push
.
b Starting at one end, carefully peel bottom
of top rail free of color panel and set the
rail inside the case.
Pull
c. Remove upper and lower bumpers by
pulling bumper away from bumper retain-
ers. Be careful not to lose the internal joint
trims on the upper bumpers.
Pull
Upper
Bumper
Internal
Joint Trim
Multi-deck Frozen Food
1-3
Lift
Push
Low Temperature