Replacing Fluorescent Lamps; Replacing Lamp Holders And End Caps - Hussmann Impact F6 Installation And Operation Manual

3. Unplug the anti-sweat heater lead.
4. Remove the foil barrier tape from the bottom
of the rail and remove the heater.
5. Install new heater, being sure to thoroughly
clean the bottom surface of the rail and to
install new foil barrier tape.
6. Plug in heater and reinstall hand rail.
7. Turn power on.
8. Verify heater is working properly.
Note: Optional handrail heaters are full-length
4, 6, 8 or 12 ft (1219, 1829, 2438 or 3658 mm) and
either 120V or 220V.

REPLACING FLUORESCENT LAMPS

Fluorescent lamps are furnished with moisture
resistant lamp holders, shields and end caps.
Whenever a fluorescent lamp is replaced, be cer-
tain to reinstall the lamp shields and end caps.
The switch in the canopy operates both the canopy
and the shelf lamps. The rail lamp switch is locat-
ed on the rail.
End Cap
Lamp Holder
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.
Plastic Shield
REPLACING LAMP HOLDERS AND
END CAPS
The Hussmann lamp holder is designed to snap
into the sheet metal of the case. The lamp holder
has a locking 'nub' which fits inside the groove of
specially designed end caps.
Hussmann
End-Cap
IMPORTANT!
Always replace lamp holders and end caps
with Hussmann lamp holders and end caps.
Use of non-Hussmann parts may result in poor
electrical contact and short lamp life.
Multi-deck Frozen Food
6-9
Groove
Nub
Hussmann
Lamp Holder
Low Temperature