System Controller Leds; Supervisor Module Leds - Cisco Nexus 9508 Hardware Installation Manual

System Controller LEDs

LED
FAN
PWR
MGMT
System Controller LEDs
The system controller module LEDs are located on the left side of the module. The following table describes
the possible states for each of these LEDs.
LED
BCN
STS
ACT

Supervisor Module LEDs

The Beacon (BCN), Status (STS), and Active (ACT) LEDs are located on the lower left front of the supervisor
module. The management port link and active LEDs are located immediately above the port on the front of
the module. The following table describes the possible states for each of these LEDs.
LED
BCN
Cisco Nexus 9508 ACI-Mode Switch Hardware Installation Guide
98
Color Status
Green Fan trays are all operational.
Amber Check the Fan Tray LEDs
Green Sufficient power is available for all the installed modules.
Amber Either of the following:
• Insufficient power for at least one of the installed modules.
• The configured power redundancy mode differs from the operational power
redundancy.
Color Status
Flashing blue The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.
Green This module is operational.
Flashing This module is booting up.
amber
Flashing red Temperature exceeds the major alarm threshold.
Off The module is not receiving power.
Green The controller module is operational and in active mode.
Amber The controller module is operational and in standby mode.
Color Status
Flashing blue The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.
for more information.
LEDs