Installing The Shelf Bracket Kit Into A Four-Post Eia Rack - Cisco MDS 9132T Installation Manual

Cisco MDS 9000 Family Telco and EIA Shelf Bracket
2
To install the shelf brackets in a Telco rack, follow these steps:
Step 1
Position a shelf bracket inside a rack-mounting post as shown in the above figure and align the screw holes at the front
of the shelf bracket with the holes in the rack-mounting post. Then attach the shelf bracket to the rack-mounting post
using a minimum of four 12-24 or 10-24 screws.
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the rack-mounting post
Note
(the hole immediately above the 1/2 in. spacing).
Step 2
Repeat with the other shelf bracket.
Step 3 Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 4 Attach the crossbar to the rear of the shelf brackets as shown in the above figure, using the 10-32 screws.

Installing the Shelf Bracket Kit into a Four-Post EIA Rack

The following figure shows the installation of the shelf bracket kit into a four-post EIA rack.
Figure 11: Installing the Shelf Bracket Kit into an EIA Rack
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
24
Shelf bracket
Installing the Cisco MDS 9132T Switch
4 Crossbar