Pattern Of Preparatory Procedures, Before Commencing A Drilling Process - ZAPbp BP93p Operator's Manual

Error messages:

If there are errors, regarding program interpretation of access to an SD card, see item 3.3.1 [Error
Messages].

Attempting to exceed physical or base coordinates.

Stopping the process: See item 2.1.8. [General error messages regarding travels],

Critical ruler errors: See item 2.1.8. [General error messages regarding travels],

Error when returning to the beginning of program: A burn occurred and the working bit of the
machine has returned to the beginning of the program currently in progress.

Error when returning to the beginning of segment: A burn occurred and the working bit of the
machine has returned to the beginning of the current segment of the program.

Excessive temperature in radiator, temperature or level of kerosene.

Burn: A burn has been detected.

The starting level of coordinate Z has been exceeded by 5mm. : When drilling, the working bit of the
machine has exceeded the starting point of the program by 5mm.

Travel Home.
5 A pattern of preparatory procedures, before commencing a EDM
process
"
1) Go to the Manual Working Mode
2) Travel the machine to the workpiece.
3) Travel away from the workpiece, according to a pre-defined value.
4) Reset the operator's coordinates: see item 2.2.1. [Operator
5) Set the appropriate physical coordinates (adjusted to the G-code applied in the working program): see
item 2.2.2. [A list of base coordinates]
"
6) Go to Programming
"
7) Go to the Automatic Working Mode
"
and position the electrode in relation to a workpiece.
"
and load the program you intend to use: see item 3.1. [List of programmes]
"
and start drilling: see item 4 [The
'
s coordinates]
"
Automatic Working Mode
"
].
25