Table of Contents
Advertisement
Stopping the process: Travel has been paused by pressing the [STOP] key.
Critical ruler error: The ruler does not report that it has completed travel, although the motor
responsible for movement along a given axis has received a message about completion of travel. This
error occurs, when:
a.
There is a motor malfunction;
b. There is a motor controller malfunction;
c.
The travelling structure produces too much resistance during movement (if that is the case, it
is recommended to clean and re-lubricate the power screw).
2.1.9 Limiting switches
If the upper of lower limiting switch has been reached, it is signalled by the following message displayed on the
"
"
"
"
screen:
k+
or
k-
, respectively, with the value of axis coordinate corresponding to the value that triggered a
limiting switch.
2.2 Configuration of coordinates
2.2.1 Operator's coordinates
Intended use: This function enables changing values for each of the operator's coordinates. This way, it is
possible to change the datum point corresponding to a local co-ordinate system, in relation to the datum point
corresponding to a global co-ordinate system.
Access path: Manual Mode [R] -> Configuration of coordinates -> Operator
Screen:
Course of action:
1) Select a specific character and the axis for which we intend to declare new operator's coordinates, by
pressing an appropriate key included in the directional keypad (see Fig. 1).
o
The entry window dedicated to the selected axis will be displayed.
.
'
s coordinates
10
Advertisement
Table of Contents
